The production method of injection pallet mold

The pallet is a kind of plastic product that people use to carry goods in daily life and the factory to carry products. The pallet is mainly made by injection molding of the pallet injection mold, and the pallet needs to adapt to different handling conditions, and the structure will usually change slightly. In particular, there are many changes in the reinforcement ribs of the pallet. At present, people will re-make a mold according to each change, resulting in a greatly increased processing cost, and the pallet injection mold is relatively big size, leading to replacement the mold is very difficult.

1. A pallet injection mold comprises a moving part and a fixing part. The moving part is provided with a ejection plate, and the ejection plate has ejection rods through the moving part. The moving part and the fixing part are respectively provided with a conflicting first switching module and the second switching module, the cross section of the first switching module and the second switching module are square. The first switching module and the second switching module four same sides are respectively provided with a forming block, The moving part and the fixing part have a first fixing groove and a second fixing groove for all the first switching module and the second switching module.

2. The side of the first fixing groove is sliding connected with a first sliding rod, and the center of the all changing module is rotating connected with the first sliding rod, and the first sliding rod is connected with the ejection plate

3. The side of the second fixed groove is sliding connected with a second sliding rod, and the center of the second switching module is rotating connected with the second sliding rod, and the second sliding rod is provided with a locking piece.

4. A conflict plate is arranged on one side of the ejection plate near the moving mold. The first sliding rod is fixably connected to the side of the conflict plate, and the conflict plate and the thimble cladding plate are connected by an elastic part.

5. An auxiliary ejector pin is arranged on the ejection plate, and the auxiliary ejector pin runs through the conflict plate and the first sliding rod in turn.

Jinnuo Mould co., Ltd. was founded in 2003, is a professional design injection mould company, there are more than 150 senior staff, construction area of 10,000 square meters. With a series of advanced processing, numerical control equipment, a set of advanced CAD/CAE/CAM technology, and in the field of daily necessities mold has a set of unique experience.

We make not only pallet mould, but also more other injection moulds, please visit our other web pages.